Guide for long-life coatings for concrete and masonry Latex finish coatings - High-build, low profile
Standards Australia
Provides a guide to the features and typical characteristics of long-life, high-build, low profile latex type finish protective coatings that are intended for exterior or interior use on concrete and masonry, when applied by airless spray or roller in accordance with the manufacturer's instructions.
RECONFIRMATION NOTICE
Technical Committee CH-003 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 30 May 2013.
Approved for reconfirmation in New Zealand on behalf of the Standards Council of New Zealand on 26 August 2013.
The following are represented on Technical Committee CH-003:
Australasian Corrosion Association
Australian Paint Approval Scheme
Australian Paint Manufactures' Federation
Australian Pipeline Industry Association
Institution of Professional Engineers New Zealand
Master Painters New Zealand Association
Water Corporation Western Australia
This Standard provides a guide to the features and typical characteristics of long-life, high-build, low profile latex type finish protective coatings intended for exterior or interior use on concrete and masonry, when applied by airless spray or roller in accordance with the manufacturer's instructions.
Paints covered by this Standard are classified as paint Type 38 of AS 2311 and correspond generally to the Australian Paint Approval Scheme specification Type 3 of GPC-C-117.
High-build, low profile latex finish coatings are water-based coatings that are designed to be used over texture coatings to elevate the exposure performance of the paint system. These coatings provide a non-aggregate, water-resistant finish which has suitable rheological properties to produce an even film coverage over an irregular surface profile provided by the underlying texture coating. They are used to elevate the performance of the underlying coating and they also provide dirt-shedding and anti-carbonation properties. These coatings are not intended for use on horizontal surfaces where water ponding is possible. They are normally specified in systems that may have a sealer and multiple coats.
These finish coatings are generally applied by 'nap roller', but can be airless spray applied, to typically achieve a spreading rate of 1.5-6.5 m2/L (0.67-0.15 L/m2). They can be used with a specified primer as 'stand-alone' coatings to provide a low relief texture, such as a 'stipple' finish produced with a nap roller.
NOTES:
1 AS/NZS 4548.5 provides a test which may be used to check the cure of concrete and masonry surfaces before applying the sealer.
2 Appendix A provides guidance on the use of long-life coatings for cement and masonry.
| Document Type | Standard |
| Status | Current |
| Publisher | Standards Australia |
| ProductNote | Reconfirmation Notice 13-09-2013 |
| Committee | CH-003 |
| Supersedes |
|
