standard byInternational Electrotechnical Commission , 10/01/2025
IEC 61000-4-30:2025 defines the methods for measurement and interpretation of results for
power quality parameters in AC power supply systems with a declared fundamental frequency of
50 Hz or 60 Hz.
Measurement methods are described for each relevant parameter in terms that give reliable and
repeatable results, regardless of the method's implementation. This document addresses
measurement methods for in-situ measurements.
This document covers two classes of measurement methods (Class A and Class S). The classes
of measurement are specified in Clause 4.
NOTE 1 In this document, "A" stands for "advanced" and "S" stands for "surveys".
Measurement of parameters covered by this document is limited to conducted phenomena in power
systems. The power quality parameters considered in this document are power frequency,
magnitude of the supply voltage, flicker, supply voltage dips and swells, voltage interruptions,
transient voltages, supply voltage unbalance, voltage harmonics and interharmonics, rapid voltage
changes, mains communicating system (MCS) voltages, magnitude of current, harmonic currents,
interharmonic currents and current unbalance.
Emissions in the 2 kHz to 150 kHz range are considered in Annex C and Annex D.
Depending on the purpose of the measurement, all or a subset of the phenomena on this list can
be measured.
NOTE 2 Test methods for verifying compliance with this document can be found in IEC 62586-2.
NOTE 3 The effects of transducers inserted between the power system and the instrument are acknowledged but not
addressed in detail in this document. Guidance about effects of transducers can be found IEC TR 61869-103.
