AS/NZS 61347.2.2:2007

Table of Contents

1 -  AS/NZS 61347.2.2:2007 Lamp controlgear Part 2.2: Particular requirements for d.c. or a.c. supplied electronic step-down convertors for filament lamps (IEC 61347-2-2, Ed. 1.2 (2006) MOD)
4 -  PREFACE
7 -  INTRODUCTION
6 -  CONTENTS
9 -  1 Scope
9 -  2 Normative references
11 -  3 Definitions
12 -  4 General requirements
12 -  5 General notes on tests
13 -  6 Classification
13 -  7 Marking
13 -  7.1 Mandatory marking
13 -  7.2 Information to be provided if applicable
13 -  8 Protection against accidental contact with live parts
17 -  9 Terminals, cables and cords
17 -  10 Provisions for earthing
17 -  11 Moisture resistance and insulation
17 -  12 Electric strength
17 -  13 Thermal endurance test for windings
17 -  14 Fault conditions
17 -  15 Transformer heating
18 -  15.1 Normal operation
18 -  15.2 Abnormal operation
18 -  16 Abnormal conditions
19 -  17 Construction
19 -  18 Creepage distances and clearances
19 -  19 Screws, current- carrying parts and connections
19 -  20 Resistance to heat, fire and tracking
19 -  21 Resistance to corrosion
20 -  Annex A (normative) Test to establish whether a conductive part is a live part which may cause an electric shock
20 -  Annex B (normative) Particular requirements for thermally protected lamp controlgear
20 -  Annex C (normative) Particular requirements for electronic lamp controlgear with means of protection against overheating
20 -  Annex D (normative) Requirements for carrying out the heating tests of thermally protected lamp controlgear
20 -  Annex E (normative) Use of constant S other than 4 500 in tw tests
20 -  Annex F (normative) Draught-proof enclosure
21 -  Annex G (informative) Explanation of the derivation of the values of pulse voltages
21 -  Annex H (normative) Tests
22 -  Annex I (normative) Particular additional requirements for independent SELV d.c. or a.c. supplied electronic step-down convertors for filament lamps

Abstract

Specifies safety requirements for electronic step-down convertors associated with tungsten-halogen lamps and other filament lamps.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Pending Revision indicates that as a result of the Aged Standards review process, the document needs updating. If no project proposal, meeting the quality criteria, is received within the 12 month timeframe, the document shall be withdrawn.
Pages
ISBN
Committee	EL-041
Supersedes	AS/NZS 61347.2.2:2004 DR 07127 CP